Repair Parts for SURGE® ALAMO 40, 30 550 Vacuum Pumps

$259.00 $7.95
(You save $251.05)
(No reviews yet) Write a Review
SKU:
ALAMO40
Note This listing has been replaced with indivdual listings for each part
 
Please order items at individual listings.  Scroll down for some item links or search for part numbers shown here;
 
Related Items for Alamo 30, 40, 550 - Some at links below;
 
7540R  Major Rebuild kit includes bearing race, seals, shims and the vanes in this listing
7540   Minor Rebuild kit includes vanes, bearings, seals, shims and vanes in this listing.
7530   Vane set of 4 (this item)
 
7750-0014-834 Small Drain Flapper for Alamo 30 tank, SP11, SP22 vacuum tanks
R137400 Rebuilt Alamo 40+ pump head only
 
67214-40  Double Oiler for Alamo 40, 550, 60 & 75 only.  Does Not fit 30 or 100
 
Parts that fit All Babson Surge Alamo Vacuum Pumps
 
7750-0210-636G Surge Alamo Vacuum Pump Oil
7750-0014-049  Gasket for 2 piece Surge Oil Reclaimer
 
7750-0214-865  Original Surge Air Filters for Vacuum Tank
7750-0020-440  Drain flapper for vacuum tank and exhaust pipe
7750-0014-889  Support for Rubber Drain Flapper 7750-0020-440
 
7510 Pump Pulley - 10 inch sheave
 
 
Call for availability of complete rebuilt pump system
 
 
 
 
 
 
Babson Surge Alamo Vacuum Pumps
 
For Surge Alamo vacuum pumps used in dairy barns and milking systems. This is a common pump sold from the 1950s to 1999. These were primarily installed with bucket systems or very small 2 cow pipeline systems.
 
The Alamo 40 had a 2 hp motor mounted on a horizontal stand.
 
The Alamo 30 had a 1.75 motor mounted on a vertical stand.
 
The pump body is about 5 inches wide and the vanes measure 4 inches long.
 
Double check model prior to ordering.
 
Rebuild kits only fit the Alamo 40 (550).
Vanes fit both models.
 
Major rebuild kit includes 4 high quality long life Kevlar vanes, 1 double row bearing, 1 needle bearing and race, 1 shaft seal, shims and 2 o-rings for later model end plates. Minor rebuild kit includes 4 high quality long life Kevlar vanes, 1 double row bearing, 1 needle bearing, 1 shaft seal, shims and 2 o-rings for later model end plates. (this kit does not have the race)
 
Set of vanes available separately above.
 
Replacement oiler system available for Model 40. The model 30 pumps had a single oiler and sealed bearings. Rubber exhaust flapper available above. Support for exhaust flapper at link below. Replacement pump pulley available. Complete rebuilt assembly available. 
 
please call to order complete assembly as this must ship on a pallet and shipping varies based on your zip code. Free shipping does not apply to complete pump assembly or vacuum pump head.
 
Pickup is available in Missouri or Pennsylvania depending on stock availability. please call
 
40+ (550) Alamo Vacuum pump specs (2.4 HP) - 20 CFM - 1025 RPM - 10 inch pump pulley - 5.5 inch Motor pulley - 2.4 hp motor
 
Items starting with 7750 are OEM GEA/WestfaliaSurge. Other parts are not made or sold by GEA®. They are quality aftermarket parts sold satisfaction guaranteed.